GCK Low Voltage Switchgear Panel
GCK Low Voltage Switchgear Panel It is suitable for power plants, petroleum, chemical industry, metallurgy, textiles, ports, high-rise buildings and other places as AC three-phase four-wire or five-wire power supply systems with voltages of 380V, 660V, frequency of 50Hz, and rated current of...
Description
GCK Low Voltage Switchgear Panel
It is suitable for power plants, petroleum, chemical industry, metallurgy, textiles, ports, high-rise buildings and other places as AC three-phase four-wire or five-wire power supply systems with voltages of 380V, 660V, frequency of 50Hz, and rated current of 5000A and below.
Technical Parameters
| Rated Working Voltage V | AC 380 |
| Rated Insulation Voltage V | AC 660 |
| Short-time Withstand Current of the Main Busbar (KA) | 500 |
| Rated Peak Withstand Current of the Busbar (KA) | 105 |
| Rated Current of the Distribution Busbar (A) | 200 |
| Short-time Withstand Current of the Distribution Busbar (KA) | 30 |
| Rated Peak Withstand Current (KA) | 63 |
| Loop of the Distribution Cabinet and Control Cabinet | 2 loops |
Conditions of Use
1. Ambient air temperature: -15℃~+40℃.
The average temperature within 24h is not higher than +35℃.
2. Altitude ≤2000m;
3. Air relative humidity: when the maximum temperature is +40℃, it should not exceed 50%. At a lower temperature, there is a higher relative humidity, such as 90% at +20°C, and it should be considered that moderate condensation may occasionally occur due to temperature changes.
4. The device should be installed with an inclination of 5° from the vertical plane.
5. The surrounding air should be free from corrosive or flammable gases, and places without frequent violent vibrations and shocks.
Note: Please contact us for confirmation when it exceeds the above normal use conditions.
Technology & details
Precautions for use
1. This product is a low-voltage power distribution cabinet that is not installed against the wall, is operated from the front, and is repaired on both sides. The maintenance channel and door of the cabinet must be operated, inspected and maintained by qualified professionals.
2. Air circuit breakers and molded case circuit breakers have been opened and closed many times. Especially after the short-circuit opening and closing, the contacts will be partially burned and carbonaceous substances will be produced, which will increase the contact resistance.
3. It is strictly forbidden to open and close the isolating switch with load.
4. After installation or maintenance, it is necessary to strictly check the isolation between compartments and functional units to ensure good functional separation of the device and prevent failures from expanding.
Company Information
Henan Fengyuan Power Technology Co., Ltd. was established in 2010 with a registered capital of 20 million yuan and is headquartered in Jiyuan City, Henan, China.
The main products are box-type substations, transformers, KYN61-40.5, KYN28A-24, KYN28A-12, XGN2-10, HXGN-10 high-voltage switchgear, XGN ring main unit, MNS, GCS, GCS, GGD, XL and other low-voltage power distribution equipment.
Certificates
Packing & Delivery
Contact us:
Henan Fengyuan Power Technology Co.,ltd
Sales Department
Contact person:Mr Charles Du
E-mail: Fengyuan800@outlook.com
Mobile:008618639199897 (Available for Whatsapp,Wechat,Skype)
Hot Tags: gck low voltage switchgear panel, China, manufacturers, suppliers, customized, Low Voltage Withdrawable Switchgear, drawer type switchgears, Indoor Low Voltage Switchgear, Low Voltage Power Distribution Cabinet, withdrawable low voltage switchgear, lv switchgear
