Drawable Low Voltage Electrical Switchgear

GCS Drawable Low Voltage Electrical Switchgear GCS low voltage draw out switchgear is suitable for power distribution systems in power plants, petroleum, chemical industry, metallurgy, textile, high-rise buildings and other industries. In large power plants, petrochemical systems and other...

Send Inquiry

Description

GCS Drawable Low Voltage Electrical Switchgear

GCS low voltage draw out switchgear is suitable for power distribution systems in power plants, petroleum, chemical industry, metallurgy, textile, high-rise buildings and other industries. In large power plants, petrochemical systems and other places with high degree of automation and requiring computer interface.

It is a complete set of low-voltage power distribution device for power distribution, centralized motor control and reactive power compensation in the power supply system with three-phase AC frequency of 50 (60) Hz, rated working voltage of 380V (400) V, (600) V and rated current of 4000A and below.

The design of the switchgear device meets the following standards

IEC439-1 "Low-Voltage Complete Switch and Control Equipment"

GB7251 "Low-Voltage Complete Switchgear"

ZBK36001 "Low-voltage withdrawable switchgear"

Drawable Low Voltage Electrical Switchgear

Low Voltage Distribution Switchgear

Conditions of Use

1. The ambient air temperature is not higher than +40°C and not lower than -5°C. The average temperature within 24 hours must not be higher than +35°C. When it exceeds, the capacity should be reduced and run according to the actual situation.

2. For indoor use, the altitude of the place of use shall not exceed 2000m.

3. The relative humidity of the surrounding air does not exceed 50% when the highest temperature is +40°C, and a larger relative humidity is allowed at a lower temperature: such as +20°C is 90%, which should be considered due to temperature changes There may be occasional effects of condensation.

4. When the device is installed, the inclination to the vertical surface is not more than 5°, and the whole group of cabinets is relatively flat (in accordance with the GBJ232-82 standard).

5. The device should be installed in a place where there is no violent vibration and impact and not enough to cause undue corrosion on electrical components.

6. When users have special requirements, they can negotiate with our company to solve them.

Factory

40.5kv Power Switchgear Price